Operation
Entering and Leaving the Operator Station
20 9831/3200-3 20
Entering and Leaving the Operator Station
General
CAUTION If the guardrails have been folded down, use extreme caution when entering and leaving the
operator station. Do not operate the controls from the platform when the guard rails are folded.
CAUTION Entering or leaving the operator station must only be made where steps and handrails are
provided. Always face the machine when entering and leaving. Make sure the step(s), handrails and your
boot soles are clean and dry. Do not jump from the machine. Do not use the machine controls as handholds,
use the handrails.
Make sure the machine is stopped, correctly parked and fully stowed before entering or leaving the platform.
Refer to: Stopping and Parking (Page 24).
When entering and leaving the platform always maintain three points of contact with the guardrails and step.
Do not use the machine controls as handholds.
Entering the Platform
1. Hold the two guardrails, then use the steps to climb up to the platform. Refer to Figure 12.
2. Depress the lever and open the platform door.
3. Step into the platform.
4. Close the platform door and make sure it latches correctly.
Leaving the Platform
1. Park the machine on solid (slabbed or paved), level ground.
2. Depress the lever and open the platform door.
3. Hold both of the guardrails and step backwards out of the platform onto the steps.
4. Close the platform door and make sure it latches correctly.
5. Use the steps to climb down backwards onto the ground.
To Next Page
Loading...
Need help?
General
