jcb S2646E User Manual

Technical Data
Fault-Finding
101 9831/3200-3 101
Fault-Finding
General
Diagnostic Trouble Codes (DTC)
Error codes can be displayed on platform control display as well as on the ground control display.
When an alarm sounds the relevant error code will be displayed on the display.
Table 51.
Display Description Lift Reaction Operator Instructions
01 System initialization fault Disables all motion Restart the machine
02 System communication Fault Disables all motion Restart the machine
03 Invalid option setting Fault Disables all motion Restart the machine
04 Load sensing data fault Warning only Contact JCB Dealer
12 Chassis up or down switch ON
at power-up fault
Disables chassis control Contact JCB Dealer
18 Pothole guard fault Disable lifting and driving Check the pothole protection
plates have fully deployed
31 Pressure sensor 1 fault Disables all motion Contact JCB Dealer
32 Angle sensor fault Disables all motion Restart the machine
36 Limp mode Lift slow to elevated speed Check the batteries are fully
charged
42 Platform left turn switch ON at
power-up message
Diagnostic message only Contact JCB Dealer
43 Platform right turn switch ON
at power-up message
Diagnostic message only Contact JCB Dealer
46 Platform joystick enable
Switch ON at power-up fault
Disables platform control Contact JCB Dealer
47 Platform joystick not in neutral
at power-up message
Diagnostic message only Restart the machine
52 Drive forward coil fault Disables lifting and driving Check that no controls are op-
erated at start-up
53 Drive reverse coil fault Disables lifting and driving Contact JCB Dealer
54 Lift Up coil fault Disables lifting and driving Contact JCB Dealer
55 Lift Down coil fault Disables lifting and driving Contact JCB Dealer
56 Right Turn coil fault Disable lifting and driving Contact JCB Dealer
57 Left Turn Coil fault Disables lifting and driving Contact JCB Dealer
58 General brake coil fault Disable lifting and driving Contact JCB Dealer
59 Parallel coil fault Disables lifting and driving Contact JCB Dealer
60 Motor controller wiring Broken Disable lifting and driving Contact JCB Dealer
61 MC eeprom fault Disables lifting and driving Restart the machine
62 MC mosfet short fault Disable lifting and driving Contact JCB Dealer
64 MC Wiring fault Disables lifting and driving Contact JCB Dealer
68 Battery low voltage Fault Disable all motion Check the batteries are fully
charged
69 MC throttle fault Disables lifting and driving Contact JCB Dealer
70 MC Main contactor Coil Short Disable lifting and driving Contact JCB Dealer
71 MC Main contactor Weld Fault Disables lifting and driving Restart the machine
72 MC main contactor driver fault Disable lifting and driving Contact JCB Dealer
77 MC over temperature cutoff Disables lifting and driving Contact JCB Dealer
80 Over 80% load warning Warning only Check the platform load
85 Pressure sensor 2 fault Disables all motion Contact JCB Dealer
86 Down limit switch fault Disable all motion Restart the machine

jcb S2646E Specifications

General

Brand	jcb
Model	S2646E
Category	Scissor Lifts
Language	English