EasyManuals Logo
Home>jcb>Scissor Lifts>S3246E

jcb S3246E User Manual

jcb S3246E
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
Operation
Getting the Machine Moving
25 9831/3200-3 25
Getting the Machine Moving
General
WARNING Watch for obstructions around machine and overhead when driving. Check clearance above, to
sides, at bottom of machine when lifting or lowering the platform.
WARNING Keep hands and arms out of the path of the scissor arms when lowering the platform.
WARNING Do not use the platform controller to release the platform when it is stuck, snagged or caught.
In this case, use the ground controller only when there are no persons on the platform.
CAUTION Do not raise platform with the guardrails folded down. The guardrails must be in their upright
positions and properly secured when raising the platform.
Raising and Lowering the Platform
Refer to: Operating Levers/Pedals (Page 29).
Operation from the Ground
1. Turn the key switch to ground control.
2. Make sure the ground and platform emergency stop buttons are pulled out.
3. Move the platform raising/lowering toggle switch either up or down. Move up to raise the platform. Move
down to lower the platform.
4. When lowering the platform the platform will stop part way down for safety. Release the toggle switch
and check there are no obstructions in the scissors. Move the toggle switch down again to fully lower the
platform. There is an intentional delay periods of 3 seconds after the stop and 1.5 seconds after the toggle
switch is pressed during lowering.
Operation from the Platform
1. Turn the key switch to platform control.
2. Make sure the ground and platform emergency stop buttons are pulled out.
3. Press the raise/lower mode button on the platform controller. The button should illuminate.
4. Press and hold the enable switch.
5. Move the joystick forwards or backwards. Check the arrow colours on the joystick with the operating
direction. Move forwards to lower the platform. Move backwards to raise the platform.
Operation in Raised Position
The automatic pothole protection system will fold down and drive speed is reduced when the platform raised.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the jcb S3246E and is the answer not in the manual?

jcb S3246E Specifications

General IconGeneral
Brandjcb
ModelS3246E
CategoryScissor Lifts
LanguageEnglish

Related product manuals