Introduction
Identifying Your Machine
19 19
9821-3100-6
Identifying Your Machine
Machine Identification Plate
Your machine has an identification plate mounted as
shown. The serial numbers of the machine and its major
units are shown on the plate.
Note: The machine model and build specification is
indicated by the PIN. Refer to Typical Product
Identification Number (PIN).
The serial number of each major unit is also shown on the
unit itself. If a major unit is replaced by a new one, the
serial number on the identification plate will be wrong.
Either get a replacement identification plate from your JCB
Dealer or simply remove the old number. This will prevent
the wrong unit number being quoted when replacement
parts are ordered.
The machine and engine serial numbers can help identify
exactly the type of equipment you have.
C051170-2
Fig 4.
Typical Product Identification Number
T034220-3
Fig 5.
1 World Manufacturer Identification (3 Digits)
2 Model Number (3 Digits)
3 Loader End Type (1 Digit)
4 Designation (1 Digit)
5 Check Letter (1 Digit)
The Check Letter is used to verify the authenticity of
the machine's PIN.
6 Machine Serial Number (8 Digits)
Each machine has a unique serial number.
O = HT Loader End
Z = ZX Loader End
S = Farmmaster
O = None Farmmaster
I = India
To Next Page
Loading...
Need help?
General
