AWM968
11
MP3/USB OPERATION
Insert/Eject Disc
Insert a disc label-side up into the disc slot (10), and the disc will begin to play. Press the eject
button (19) to stop playback and eject the disc.
Insert/Remove USB Device
To connect a USB device, locate the USB interface connector (20) located near the bottom
right corner on the front of the radio. Insert the USB device into the USB jack and the unit will
read the files on the USB device automatically, displaying “USB LOAD” while files are initially
loaded. To remove the USB device, press the FM/AM button (6), DVD/USB button (8) or AUX
button (7) to change to another mode and then remove the USB device from the USB
connector.
Press the DVD/USB button (8) to access USB mode from any other mode.
NOTE: MP4 streaming video format is not supported.
MP3 Monitor Display
After loading an MP3 disc or USB device, the following screen will appear on your output
monitor.
Select one of these icons to access the corresponding media on your disc or USB device. If the
media type is not present, the icon will not be selectable.
• : Audio
• : Photos
• : Video
Play/Pause
Press the 2/ button (28) to suspend or resume playback.
Track Select
When playback is stopped, press the TUNE/SEEK/TRACK >>| or |<< button (13, 14) to search
in current folder. During playback,
press the TUNE/SEEK/TRACK >>| or |<< button to access
the previous/next file. The selected file number will appear on the display.
Folder Up/Down
Press and hold the 6/RPT button (32) to access a higher folder level (FOLDER UP).
Press and hold the 5/ button (31) to access a lower folder level (FOLDER DN).
Repeat (RPT)
Press the 6/RPT button (32) on the control panel or the RPT button (21) on the remote control
multiple times during playback to select from the following repeat play options: REP 1 (track),
REP DIR (folder), REP ALL (disc), OFF.
To Next Page
Loading...
Need help?
General
