6
BASIC OPERATION
Power
Press the POWER button (4) to turn the unit on or to enter standby mode.
Volume Control
Press the VOL + to increase the volume output. Press and hold the VOL + to increase the
volume output continuously.
Press the VOL - to decrease the volume output. Press and hold the VOL - to decrease the
volume output continuously.
Mode / Menu
Press the MODE/MENU button (7) to switch to radio mode or auxiliary input function.
Press and hold the MODE/MENU button (7) to choose the following menu list:
Audio Adjustment
BAS: Adjust the Bass level from “-7” to “+7”.
TRE: Adjust the treble from “-7” to “+7”.
BAL: Adjust the speaker output balance between “L7” (left) and “R7” (right). “BAL 0”
indicates an equal balance between the left and right speakers.
FAD: Adjust the speaker fade between “R7” (rear) and “F7” (front). “FAD 0” indicates an
equal balance between the rear and front speakers.
Use the VOL +/- to make adjustments in each menu item
Liquid Crystal Display (LCD) Back Light
Dimmer: Adjust the brightness of the LCD from “LIGHT 9” (brightest) to “LIGHT 0” (off).
NOTE: When subjected to cold temperatures for an extended period of time, LCD panels
will take longer to illuminate and the display visibility may slightly decrease. Optimal LCD
operation will return to normal when the temperature increases to a normal range.
Sleep Mode
Sleep: The Sleep Timer will automatically turn off the JWM1A in the designated number of
minutes. To set the Sleep Time, press VOL +/- repeatedly to change the sleep time from
0(off), 15, 30 or 60 minutes.
Setting the alarm
Alarm ON/OFF: Press VOL +/- to turn on and off the alarm. The “ALARM” icon will show
on the display.
Alarm Hour: The number representing the hours will flash. Press VOL +/- to adjust the
alarm hour.
Alarm MIN: The number representing the minutes will flash. Press VOL +/- to adjust the
alarm minute.
Reset
RESET: Press 6/ENTER button (13) to reset to factory default settings. Display will show “OK”
when Reset is accomplished. This function will time out after 5 seconds of inactivity and the unit
will resume normal operation.
Mute / Loudness
Press the MUTE/LOUD button (8) to silence the audio output in tuner, Bluetooth or
auxiliary/input mode. Press again to restore the previous volume level. Press and hold the
MUTE/LOUD button to toggle the Loudness function on/off. Display will show “LOUD” when on.
Auxiliary Input Function
Press the MODE/MENU button (7) to directly access auxiliary input modes from any other mode
when a portable audio device is connected to the unit. To connect a portable audio device, insert
a standard 3.5 mm (audio line output or headphone output from your portable CD / MP3 / iPod
or other media player) into the AUX IN connector (6) on the front of the unit. Display will show
when on.
Auxiliary Input Connector
Connect the device to the AUX IN connector (6) on the front panel, and then press
MODE/MENU to switch to auxiliary input mode.
To Next Page
Loading...
Need help?
General
