8
Unpacking
Open shipping container and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the Drum
Sander is assembled and running properly.
Compare the contents of your container with the
following parts list to make sure all parts are
intact. Missing parts, if any, should be reported
to your distributor. Read the instruction manual
thoroughly for assembly, maintenance and
safety instructions.
Contents of the Shipping Container
Refer to Figure 2
Box 1:
1 Drum Sander
1 Handwheel
1 TUF Tool
1 Abrasive Strip (already installed on drum)
1 Owner’s Manual (not shown)
1 Warranty Card (not shown)
1 Hardware Bag containing:
4 Socket Head Cap Screws, 5/16”-18x3/4”
4 Lock Washers, 5/16”
4 Flat Washers, 5/16”
4 Hex Cap Screws, 3/8”-16x3/4”
4 Flat Washers, 3/8”
3 Hex Wrenches, 1/8”, 4mm and 6mm (not
shown)
Box 2:
1 Conveyor Assembly
Read and understand the
entire contents of this manual before
attempting set-up or operation. Failure to
comply may cause serious injury.
Figure 2
To Next Page
Loading...
Need help?
General
