Safety Checklist
BEFORE EVERY RIDE, CONDUCT THESE IMPORTANT SAFETY CHECKS.
BRAKES
• Make sure brakes work properly.
• Check that the brake pads are not worn, are aligned, and centered correctly.
• Check that the brake control levers are lubricated and secured to the handlebar.
STEERING
• Check that the handlebar and stem are aligned with the forks and are securely tightened.
CRANKS AND PEDALS
• Check that the pedals are securely tightened to the cranks and that the cranks are tightened.
WHEELS AND TIRES
• Make sure that the tires are inlated to within their maximum recommended tire pressure: 35-45 PSI.
• Check tires for excessive wear or any damage.
• Check that the wheel rims are not damaged.
• Check that wheel spokes are not broken and that the nuts on the axles are tight.
CAUTION: Use a hand or foot pump designed for bicycle tires. Never inlate tires with an air compressor
at a gas station. This can cause the tubes to over-inlate and blow out.
CHAIN
• Make sure all bearings are lubricated and run smoothly.
FRAME AND FORK
• Check that the frame and fork are not damaged or broken.
ONE-YEAR GENERAL LIMITED WARRANTY
All new Jetson products, excluding parts and accessories, are warranted against defects in materials and workmanship
for a period of one year from the date of original retail purchase when used in accordance with Jetson's user manuals
(refer to ridejetson.com/support).
Under this warranty, you will be able to direct your claims to Jetson even in situations where you purchased the
Jetson Product from one of our authorized retailers.
To read the full terms of our warranty, visit www.ridejetson.com/pages/warranty-policy.
To Next Page
Loading...
Need help?
General
