1.5 Setting Your Electronic Passcode
YOU CAN ALSO USE A 3DIGIT ELECTRONIC PASSCODE TO LOCK AND UNLOCK YOUR SCOOTER.
THE DEFAULT PASSCODE IS 333. YOU CAN CHANGE IT AT ANY TIME.
NOTE: YOU WILL NEED ONE OF THE INCLUDED NFC TAGS TO CHANGE FROM THE DEFAULT PASSCODE.
IMPORTANT: MAKE NOTE OF YOUR PASSCODE. THERE IS NO WAY TO RESET THE PASSCODE OR USE IT TO UNLOCK THE
SCOOTER WITHOUT IT.
TO CHANGE THE PASSCODE:
1. PRESS AND HOLD THE POWER BUTTON FOR 2 SECONDS TO TURN ON YOUR SCOOTER. NOTE THE GREEN SPINNING
CIRCLE AND LOCK ICON ON THE LCD SCREEN.
2. TAP AND HOLD ONE OF THE NFC SECURITY TAGS ON THE NFC SENSOR UNTIL YOU HEAR TWO BEEPS AND THE LOCK
ICON DISAPPEARS FROM THE LCD SCREEN.
3. PRESS AND HOLD THE POWER BUTTON FOR 3 SECONDS WHILE YOU TAP AN NFC SECURITY TAG TO THE NFC SENSOR.
RELEASE THE BUTTON AND TAG WHEN:
· THERE IS THE SOUNDING OF 2 BEEPS
· THE GREEN CIRCLE BEGINS TO BLINK.
4. QUICKPRESS THE POWER BUTTON 5 TIMES IN A ROW TO ENTER THE PASSWORD SECTION OF THE SETTINGS MENU.
5. QUICKPRESS THE THROTTLE UNTIL THE DIGIT THAT YOU WANT FOR THE FIRST PASSCODE POSITION APPEARS
ON THE DISPLAY.
NOTE: DIGITS RANGE FROM 1 TO 9. CONTINUING TO PRESS THE THROTTLE AFTER A "9" APPEARS WILL CYCLE
IT BACK TO "1."
6. PRESS THE POWER BUTTON ONCE TO CHOOSE THAT NUMBER.
7. REPEAT STEPS 5 AND 6 FOR THE SECOND POSITION.
8. REPEAT STEPS 5 AND 6 FOR THE THIRD POSITION. TWO BEEPS CONFIRM THAT A NEW 3DIGIT PASSCODE HAS BEEN
SUCCESSFULLY SET.
To Next Page
Loading...
Need help?
General
