• Printer should be cleaned regularly so that there's no dust or other residues accumulated.
• During printing,
1.Model should not exceed the actual build volume of the printer.
2.Printer should not be running overload.
3.If there's unusual noise or vibration, you're recommended to clean and lubricate the rails.
3.1.Wiping with a clean dry cloth.
3.2.Apply the lubricating oil on the rails.
3.3.Move the moving parts back and forth to ensure enough lubrication.
• Always pull the remaining filament out of extruder and keep it under seal in cool and dry place.
• Do not disassemble the printer. If you do so, make sure you put every part back to original position.
• Power off the printer and wait for at least 10s before changing SD card.
• 1~3 hours interval is necessary if printer runs over 96 consecutive hours.
Maintenance
29
To Next Page
Loading...
Need help?
General
