JL AUDIO CleanSweep™ CL441dsp 13
SPECIFICATIONS
CleanSweep™ CL441dsp
OEM Interface / Processor
ELECTRICAL SPECIFICATIONS:
Power Supply Type
: PWM Switching Supply - Regulated
Operating Voltage
: 9 - 16V DC
Standby Mode Current Draw
: < 2 mA
Operating Current Draw
: 0.5 A at 13.8 V
Recommended Fuse Value: 1 A (Fast Blow)
Recommended Fuse Type: AGC
OEM INPUT SECTION:
No. of Input Channels:
Four
Input Type:
Differential-balanced with multi-pin jack / plug
Input Range:
100mV - 30V RMS
Input Level Setting: Fully Automatic
AUX INPUT SECTION:
No. of Input Channels: Two (feed all four output channels)
Input Type: Differential-balanced with dual RCA jacks
Input Range: 250mV - 4V RMS
Input Level Setting: Manual with individual level trim
controls and LED clipping indicators
DIGITAL SPECIFICATIONS:
Processor: 32 bit SHARC
®
floating point DSP
Audio Resolution: 24 bit
No. of EQ Bands: 120 (30 x 4 channels)
EQ Resolution: 1/3 octave from 25 Hz - 20 kHz
OUTPUT SECTION:
No. of Output Channels: Four
Output Type: Unbalanced, via RCA Jacks
Maximum Output Voltage: 8V RMS (per output)
Output Impedance: 470 ohms
Signal to Noise Ratio: >102 dB (A-Weighted, referenced to
rated output)
THD + Noise: < 0.01% at rated output (20Hz - 20 kHz)
DIMENSIONS: (LxWxH):
9.72 in. x 4.37 in. x 1.54 in. (247 mm x 111 mm x 39 mm)
Due to ongoing product development, all specifications are
subject to change without notice.
U.S. and International Patents Pending
To Next Page
Loading...
Need help?
General