Button Definition and Function
S1 Play/Pause music / Refuse incoming call
S2 Next Song
S3 Previous Song
S4 On/Off , Pairing, Accept call
S5 Volume up
S6 Volume down
LED light indicators
How to pair your JLab GO Bluetooth headset with your
Bluetooth compatible device:
Pairing is a process that securely connects Bluetooth enabled devices to each other. The
process will only have to be done once per device that you wish to connect. Please follow the
steps below to pair your JLab GO Bluetooth headset to your Bluetooth capable device.
1. Press and hold the S4 key for 10 seconds or until the red & blue lights start flashing
alternately. Release the S4 button and quickly press once again. The device is now ready to
be paired with another Bluetooth compatible device.
2. Begin to pair with your compatible device (Please refer to device user manual). A search
for devices will show “JLab-1BT” in your device list. Select this device.
3. You will be required to enter Pin-Code: Enter Pin-Cod: 0000
4. Pairing is now complete.
Note:
It the JLab headset can’t find a device to pair with within 3 minutes, it will automatically shut-down.
In order to pair the 2 devices, the headset and the device must both be in pairing mode.
To Next Page
Loading...
Need help?
General
