General Use
Power On:
Press and hold the S4 key for 2 seconds or until the blue and red LED flashes and then release. The
headset will then attempt to connect to previously paired devices. If successful one of 3 things will
happen:
1. Red light will flash slowly, indicating a mono connection
2. Blue light will flash slowly, indicating a stereo connection
3. Blue and red lights will flash slowly indicating a mono and stereo connection (most smart
phone connections will connect with mono and stereo)
Power Off
Press and hold the S4 key for 2 seconds or until the blue and red LED flashes and then release. The
device is now powered off.
Dial, Talk and End calls
After the JLab GO Bluetooth Headset has paired with your mobile device, you can use the headset
to make and receive phone calls.
Receive a call:
You will be notified of an incoming call by a ringing sound through both earbuds. To accept the
call simply depress the S4 button quickly and speak normally. To hang up, press the S4 button
again.
Refuse a call:
If you wish to refuse an incoming call, press the S1 button.
Adjusting the call volume:
To adjust the volume of the speaker while talking press the volume up bottom. To lower the
volume press the volume down button. Once you reach the maximum or minimum volume
points, a gentle beeping sound will be heard through both earbuds.
Listening to Music
After the JLab GO Bluetooth Headset has paired with your mobile device or MP3 player, you can
use the headset to listen to and control music. Please follow the instructions included with your
device to change the speaker output to JLab-1BT.
Play/Pause Music
To play and pause music press button S1. If you wish to move to the next song press button S2
and if you wish to hear the previous song press button S3.
Playing music, press S3 key quickly to next song.
To Next Page
Loading...
Need help?
General
