602B-B01A-NB Issue Date 04 2013
1
T5000 LCD Digital Fan Coil Thermostat-Installation Instructions
T5000 液晶数字式风机盘管温控器-安装说明
42mm
41mm
15mm
60mm
88mm
8mm
52.5mm
88mm
8mm
Application
T5000 series thermostats are designed to on/off control the fans and valves in
air conditioner applications via comparison of the room temperature and setting
temperature as reaching the aim of comfort and saving energy.
T5000 are microprocessor based thermostat with LCD display. It shows the following
items: working states (cool/heat/ventilation), fan speed, room temperature, settin
g
temperature. T5000 features with one on/off button (
)、one mode button (
M
)、one
fan speed selection button (
), two adjustment buttons (▲
▼
).
图
2
:
T5200-TC/TB/TF-9JS0、T5200-TB-9JR0系列温控器尺寸 (mm)
Figure
2
:
T5200-TC/TB/TF-9JS0、T5200-TB-9JR0 Series Thermostat Dimensions in (mm)
图
3
:
T5200-TF-9JR0系列温控器尺寸 (mm)
Figure
3
:
T5200-TF-9JR0 Series Thermostat Dimensions in (mm)
安装
T5000温控器安装在用户容易观看屏幕和调节温度设定点的地方。并使温控器位
于能代表房间总体环境温度的地方。避免将温控器安装于冷热源附近，如通风
口、加热器、室外或阳光照射到的地方。
安装
T5000系列温控器设计为标准75x75x35mm墙装接线盒安装。 (见
图4
) 按照指示
打开后盖底座，把它安装在墙上并接线。
注意
:
所有T5000系列温控器型号，需要两枚M4x25安装螺钉 (不包含)。
Installation
Install the T5000 where the occupant can read the display and adjust the setpoint
easily. Situate the thermostat where the temperature is representative of the general
room conditions. Avoid installing the T5000 near cold or warm air drafts, radiant heat,
on an outside wall, or in direct sunlight.
Mounting
Mount the T5000 Series thermostat to a 75x75x35mm standard electrical wallbox. (See
Figure
4
)
Follow the instruction in Removing the Base and then proceed to the Wall Mounting
and the Wiring sections.
Note:
All T5000 Series models require two M4x25 mounting screw (not included).
应用
T5000系列风机盘管温控器，适用于中央空调风机盘管系统的室内温度控制，通
过室内温度和设定温度相比较，对空调系统末端的风机盘管及电动阀进行开启
和关闭控制，达到调节室内温度、舒适及节能的目的。
T5000采用微电脑控制技术，大屏幕液晶显示，液晶显示状态有：工作状态（制
冷、制热、通风）、风机风速、室内温度、设置温度等。按键有：电源开关 (
)、
模式转换键（
M
）、风速选择键 (
) 及温度设置键（▲
▼
）。
602B-B01A-NB Issue Date 04 2013
This document is subject to change without notice 本文档如有变化，恕不另行通知
图
1
:
T5000液晶数字式风机盘管温控器
Figure
1
:
T5000 LCD Digital Fan Coil Thermostat
1
4
2
2×1.5mm
2
OR
1×2.5 mm
2
3
M4X25
墙装盒安装
安装T5000系列温控器:
把外部接线从墙里拉出并通过打开的方形底座。
通过两个安装孔，把底座固定在安装盒上，如
图2和图3
两枚M4x25螺钉。
根据应用产品的要求进行正确的接线。
Wallbox Mounting
To mount the T5000 Series Thermostat:
Pull the external field wiring from the wall through the rectangular opening in the base.
Fasten the base to the wallbox using the appropriate two holes, as shown in
Figure
2
and Figure
3
, and two M4 x 25 screws.
Proceed to the Wiring section for
the correct configuration for the application and units.
图
4
:
上图为T5200-TC/TB/TF-9JS0及T5200-TB-9JR0安装图 (T5200-TF-9JR0安装方法一致)
Figure
4
:
Installation diagram of T5200-TC/TB/TF-9JS0 and T5200-TB-9JR0 (Same procedure for T5200-TF-9JR0)
To Next Page
Need help?
General
