Menu Overview
There are three menus used to view, program, and
configure the TEC2100 Series thermostats. The
menus are:
• Status Display Menu
• Main User Menu
• Installer Configuration Menu
The following sections outline the functions and
contents of each menu.
Status Display Menu
The Status Display Menu is displayed during normal
thermostat operation. The menu continually scrolls
through the following parameters:
• Room Temperature
• System Mode
• Schedule Status
• Outdoor Temperature (requires outdoor air
temperature sensor)
• Applicable Alarms
Press the up arrow/SCROLL key to temporarily stop
the scrolling.
Main User Menu
The Main User Menu is used to access and change
the thermostat’s basic operating parameters. The
Main User Menu is accessed by pressing the MENU
key during normal thermostat operation. This menu
is most commonly used by the zone occupant and is
comprised of the following parameters:
• Temperature Setpoints
• System Mode
• Fan Mode
The Main User Menu uses Auto Help. Auto Help is
displayed automatically in the Main User Menu when
there is a pause in programming activity.
Installer Configuration Menu
The Installer Configuration Menu is used to set up
the thermostat for application specific operation. The
menu is accessed by removing the front cover and
pressing the configuration key, labeled CONFIG
(see Figure 2).
This Installer configuration Menu is used by the
installer/commissioning technician and contains the
following parameters:
• Digital Input Configuration
• Keypad Lockout Levels
• Power Delay on Power-up
• Frost Protection
• Maximum Heating Setpoint/Minimum Cooling
Setpoint
• Anti-Short Cycle Timings
• Heating Stages Cycles per Hour
• Cooling Stages Cycles per Hour
• Minimum Deadband
• Heating Fan Control
• End of Cycle Fan Delay
• Temporary Occupancy Time
• Room Sensor Calibration
• Outdoor Air Sensor Calibration
• Number of Heating Stages (TEC2103-1 and
TEC2104-1 only)
• Number of Cooling Stages (TEC2103-1 or
TEC2104-1) Number of Heat Pump Stages
(TEC2102-1)
• Outdoor Air Temperature Heating Lockout
• Outdoor Air Temperature Mechanical Cooling
The following parameters are for the TEC2102-1
only:
• Low Balance Point
• High Balance Point
• Comfort/Economy Heat Pump Operation
• Reversing Valve Operation
• Compressor/Auxiliary Interlock
The following parameters are for the TEC2104-1
only:
• Outdoor Air Changeover Setpoint
• Outdoor Air Damper Minimum Position
• Mechanical Cooling Enable/Disable with
Economizer Operation
• Mixed Air Temperature Setpoint
• Mixed Air Temperature Display
4 TEC2100 Series Networked Thermostats Product Bulletin
To Next Page
Loading...
Need help?
General
