Johnson Level & Tool 40-6601 User Manual

8
©2021 Johnson Level & Tool - Rev. 2
6. Operating Instructions
IMPORTANT: It is the responsibility of the user to ensure proper
maintenance of the Self-Leveling Cross-Line Laser. Conduct
periodic test measurements to ensure the tool is measuring
accurately and consistently. This is most important if the tool has
been exposed to extreme temperatures or moisture. Keep the
Self-Leveling Cross-Line Laser optic lens clean and inspect
for damage.
Battery Installation
To install batteries in the Self-Leveling
Cross-Line Laser:
1. Remove the battery cover, which is located at
the back of the tool, by pressing the battery
cover release tabs found on the left and right
sides of the tool and pulling the cover straight
out from the tool housing.
2. Insert 2 “AA” batteries into the battery compartment according
to the polarity illustrated inside the battery compartment.
3. Replace the battery cover. Press in the release tabs as you
insert them into the tool housing.
• Always check that the locking compensator/power switch is in the
locked position before removing and replacing batteries.
• Use only alkaline batteries.
• Remove the batteries when storing the tool for an extended time
(more than 3 months)
to avoid damage to the tool should the
batteries deteriorate.
Note:

Johnson Level & Tool 40-6601 Specifications

General

Brand	Johnson Level & Tool
Model	40-6601
Category	Measuring Instruments
Language	English