12
Installing the Canopy
• Zip the back of the canopy to the top of the seat. (13)
• Attach the canopy’s brackets to the sides of the seat frame by hooking them into place. (14)
• The canopy can be adjusted to be fully opened or closed. (15)
• The canopy can be made larger by unzipping the extension zipper and pulling the canopy open.
(16)
• The mesh window can be left opened or closed. Unfold the fabric ap on the back of the canopy
for the opened position. Fold the fabric ap over the mesh for the closed position. (17)
IWARNING: Possible pinching hazard – Be careful when
closing and opening the side hinges so as not to pinch your ngers.
ALWAYS zip canopy onto the stroller frame when in use. NEVER operate
the stroller without the canopy completely zipped.
Installing/Removing the Bumper Bar
• Remove the two safety caps from the seat mount points by pressing the release button and pulling
each cap o.
• To attach the bumper bar, orient it with the male tting pointed towards the seat. While holding the
male ttings straight, insert the male ttings on the bumper bar into the female ttings located on
both sides of the seat until it snaps into place. (18) Pull outward on the bumper bar to ensure it is
secure.
• To remove, press the buttons located on the underside of both male ttings inward and pull the
bumper bar away from the seat. (19)
• When using the stroller without the bumper bar, always replace the safety caps.
To Next Page
Loading...
Need help?
General
