Straight stitching and
needle position
Turn the stitch selection dial so
that the pointer is set to the
straight stitch.
Generally speaking, the thicker
the fabric, thread and needle,
the longer the stitch should be.
Choose your needle position,
from center position to left
needle position by changing the
stitch width dial from "0" to "7".
703.5
Zigzag stitching
Turn the stitch selection dial to
zigzag stitch.
The maximum zigzag stitch
width for zigzag stitching is "7";
however, the width can be
reduced on any patterns. The
width increases as you move
zigzag dial from "0" - "7". For
twin needle sewing, never set
the width wider than "4". (1)
The density of zigzag stitches
increase as the setting of stitch
length dial approaches "0".
Neat zigzag stitches are usually
achieved at "2.5" or below. (2)
Closed up zigzag stitches
(close together) are referred to
as a satin stitch. Set the stitch
length between "0" - "1".
Function of zigzag dial
Function of stitch length dial
while zigzaging
Satin stitch
74321065
4
3
21
0.5
To Next Page
Loading...
Need help?
General
