JUKI LU-1510N-7 User Manual

–59 –
No. Portion to which LOCKTITE is applied Part No. LOCKTITE No.
1 Feed adjusting rod hinge screw SD0800402TP LOCKTITE #638
2 Vertical change base arm pin 10715308 LOCKTITE #638
3 Alternate dial shaft bushing 10715100 LOCKTITE #638
4 Cylinder connecting screw hinge screw SD0720331SP LOCKTITE #243
5 Alternate vertical change base support shaft setscrew SS8150710SP LOCKTITE #243
6 Thread release bar 21441209 LOCKTITE #243
7 Inner hook guide crank pin lock nut NS6110420SP LOCKTITE #243
8 Automatic presser foot lifter lever shaft 21356704 LOCKTITE #243
4. PORTION TO WHICH LOCKTITE IS APPLIED
LOCKTITE has been applied to the following parts at the time of assembly at the factory.
Avoid disassembling these parts to the most. When an assembly which includes the aforementioned parts
has been forced to be disassembled, be sure to wash the LOCKTITE applied part using a paint thinner or
the like, and reassemble it using LOCKTITE after removing any moisture from the mating faces.
If it is hard to remove a part which has been fixed using LOCKTITE, heat it using a torch lamp or the like to
help remove the part.
No.1 No.2
No.3
No.4
No.5 No.6
Thread release bar
LOCKTITE applied
Thread release bar coupling
Thread release bar coupling nut
Setscrew
LOCKTITE applied
Vertical change base
support shaft
Cylinder connecting screw
LOCKTITE applied
Cylinder connecting
screw hinge screw
Feed adjusting rod
Fedd adjusting base
LOCKTITE applied
Feed adjusting rod hinge screw
Vertical change base arm pin
LOCKTITE applied
Vertical adjusting arm
Alternate dial shaft bushing
LOCKTITE applied
Top cover B
No.7 No.8
Automatic presser foot
lifter lever shaft
Inner hook guide crank pin
Inner hook guide arm
Inner hook crank
pin lock nut
LOCKTITE applied
LOCKTITE applied

JUKI LU-1510N-7 Specifications

General

Brand	JUKI
Model	LU-1510N-7
Category	Sewing Machine
Language	English