Preparing the machine
Attaching the foot control
Plug foot control into the machine socket (A) and then into the main
socket (B). The foot control regulates the sewing speed. The sewing
speed can be adjusted by increasing or decreasing the pressure on
the foot control.
“WARNING”
This appliance has a polarised plug (one blade wider than the oth-
er). To reduce the risk of electrical shock, this plug is intended to t
into a polarised main socket only one way. If the plug does not t
fully in the polarised main socket, reverse the plug. If it still does not
t, contact a qualied electrician to install the proper polarised main
socket. Do not modify the plug in any way.(for USA, Canada only).
* Use only the foot control model YC-482 (USA, Canada), YC-483N
(220-240V).
Thread stand
Push the support rod rmly into the socket on the back of the ma-
chine. Raise the support rod (C) fully, turning slightly until the po-
sition catches engage. Position the thread guide (D) on the thread
stand so that the arrow is to the front.
Polarized power
supply socket
Polarized For UL, CSA
7
To Next Page
Loading...
Need help?
General
