ON
I
O
OFF
Raise the support rod fully,
turning slightly until the
positioning catches engage.
The anti-vibration cone should
be used with the wider edge to the
bottom on the spool holder
pin when sewing with cones.
When using household spools
remove the anti-vibration cones.
Place spool on spool holder pins
and push the spool caps on.
If threads slip and get twisted,
cover the spools with the nets
supplied in the accessory box.
The power switch is conveniently
placed on the handwheel side of
the machine.
"I"-ON
"O"-OFF
Plug foot control into machine
socket (A) and then into main
socket (B).
The sewing speed can be
adjusted by increasing or
decreasing the pressure on the
foot control (C).
Preparing the machine
Assembling the thread stand
Thread cones
Power/light switch
Attaching the foot control
Sewing speed
B
A
Press in
Spool cap
Thread spool
Anti-spill net
11
To Next Page
Loading...
Need help?
General
