Juniper SRX300 Manual

How to Set Up Your SRX300 Services Gateway
2
Factory-Default Settings
Security Policies
Source Zone Destination Zone Policy Action
trust untrust permit
trust trust permit
NAT Rules
Source Zone Destination Zone Policy Action
trust untrust Source NAT to untrust zone
interface
Interfaces
Port Label Interface Security Zone DHCP State IP Address
0/0 and 0/7 ge-0/0/0 and
ge-0/0/7
untrust Client Unassigned
0/1 to 0/6 VLAN Interface
irb.0 (ge-0/0/1
to ge-0/0/6)
trust Server 192.168.1.1/24
Services
Services
SSH
HTTPS
NETCONF over SSH
Protocols
Protocols
RSTP (all interfaces)
Screens
Screens
Basic set of screens are enabled on the untrust zone
Device Startup Mode
Device Startup Mode
Switching
Initial Configuration Process
g04361
6
Install Device
in a Rack
Connect the
Grounding Cable
Power On
the Device
Verify the
Settings
Configure
Using ZTP/J-Web
Connect to
Management Device
NOTE: Before you begin the installation, see the Safety Guide at https://
www.juniper.net/documentation/hardware/safety-guide/translated/index.
html.
Install the Device in a Rack
1. Position a mounting bracket on each side of the chassis. Use a number-1
Phillips screwdriver to install the screws that secure the mounting brackets
and power supply adapter tray to the chassis.
SRX3 00
g005160
2. Place the power supply adapter in the tray.
SRX3 00
g00516
1

Juniper SRX300 Specifications

General

USB 2.0 ports quantity	1
Connectivity technology	Wired
SFP module slots quantity	2
Ethernet LAN (RJ-45) ports	6
Internal memory	4000 MB
Flash memory	8000 MB
Storage media type	Flash
Power consumption (typical)	15.4 W
Noise level	0 dB
Heat dissipation	85 BTU/h
Concurrent connections	64000
Mean time between failures (MTBF)	389820 h
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 90 %
Routing protocols	BGP, CLNS, IS-IS, OSPF, RIP-1, RIP-2
Number of users	50 user(s)
Quality of Service (QoS) support	Yes
Firewall throughput	1000 Mbit/s
Mobile VPN IPSec	250
IPS/IDS throughput	100 Mbit/s
Harmonized System (HS) code	85176990

Weight and Dimensions

Weight	1980 g
Dimensions (WxDxH)	320.8 x 34.7 x 191 mm