no Negate a command or set its default(s)
priority Specify the priority
protocol Specify the protocol
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
use Configure usagehost1(config-dos-protection-group)#?
Drop Profile Configuration Mode
In this mode, you can configure drop profiles for QoS. Drop profiles control RED
dropping behavior.
From Global Configuration mode, type the drop-profile command, and press Enter.
host1(config)#drop profile
host1(config-drop-profile)#?
average-length-exponent Select TAQL coefficient
committed-threshold Specify committed queue thresholds and maximum drop
probability
conformed-threshold Specify conformed queue thresholds and maximum drop
probability
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exceeded-threshold Specify exceeded queue thresholds and maximum drop
probability
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
Explicit Path Configuration Mode
From this mode, you can name and configure an explicit path within MPLS.
From Global Configuration mode, type mpls explicit-path name and the
explicitPathName, and press Enter.
host1(config)#mpls explicit-path name xyz
host1(config-expl-path)#?
append-after Add an entry after a specified index
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
index Specify the index of the entry to be added or edited
list List part or all of the entries in current explicit path
log Configure logging settings
macro Run a CLI macro
next-address Configure an IP address at the last hop of the explicit path
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
Accessing Command Modes â– 95
Chapter 2: Command-Line Interface
To Next Page
Need help?
General
