8
The symbols on the display mean:
HARDNESS
LEVEL — Water hardness function switched off
HARDNESS German water hardness 1 – 7°
LEVEL 1 French water hardness 1.79 – 12.53°
HARDNESS German water hardness 8 – 15°
LEVEL 2 French water hardness 14.32 – 26.85°
HARDNESS German water hardness 16 – 23°
LEVEL 3 French water hardness 28.64 – 41.14°
HARDNESS German water hardness 24 – 30°
LEVEL 4 French water hardness 42.96 – 53.7°
The machine is adjusted to HARDNESS LEVEL 3 in the factory.
You can alter this setting by proceeding as follows:
Pull the plug and the feed wire out of the wire box on the back
of the machine.
Put the plug in.
Switch the machine on by pressing the ON/OFF key.
The machine goes into the starting position fully automatically.
PLEASE WAIT
Press the key P until you hear an acoustic signal.
FILTER NO
Press the key a number of times in succession until the fol-
lowing report appears:
HARDNESS LEVEL 3
If you press key P, you hear an acoustic signal and the hardness
level you have set flashes.
If you press the keys and you can now set the required
hardness level.
When you have selected the corrected hardness level, press the
key P once more as a confirmation. You can hear an acoustic
signal.
Press the keys and until the following report appears:
EXIT
Press the key P to return to stand-by status.
4. First start of operation
4.1 Fill system with water
Switch your machine on with the ON/OFF switch.
The machine goes into the starting position fully automatically.
Place an empty cup under the pivoting nozzle (14).
PLEASE WAIT
OPEN TAP
SYSTEM FILLING / PLEASE WAIT
The flow of water stops automatically.
CLOSE TAP
5. Rinsing the machine
RINSE UNIT
Place an empty cup under the coffee-spout (10).
Press the rinsing key .
If the machine has been switched off and has already cooled
down, the rinsing function will be demanded when the
machine is switched on.
A rinsing is automatically started when the machine has been
switched on.
To Next Page
Loading...
Need help?
General
