5
English
(Please refer to instructions for speakers as will when you connect speakers.)
Connecting the Speakers
For each speaker, connect one end of the speaker wire to the speaker terminals on the back of the
CA-D672TR and the other end to the speaker.
1. Open each of the terminals and insert the speaker wires firmly (be sure to remove the insulation
at the end of each wire first), then close the terminals.
2. Connect the red (+) and black (–) terminals of the right side speaker to the red (+) and black (–)
terminals marked RIGHT on the CA-D672TR.
Connect the red (+) and black (–) terminals of the left side speaker to the red (+) and black (–)
terminals marked LEFT on the CA-D672TR.
Right speaker
Left speaker
IMPORTANT: Use speakers with the correct impedance only. The correct impedance is indicated on
the back panel.
CAUTION: If a TV is installed near speakers, the TV may display irregular colours. In this case, set
the speakers away from the TV.
123
Connecting a VCR
Connect the VCR to the VCR terminal.
CAUTION: Make all connections before plugging the Unit into an AC power outlet.
RIGHT LEFT
VCR
IN
(PLAY)
OUT
(REC)
AUDIO OUT
AUDIO IN
Now you can plug the AC power cord into the wall outlet, and your CA-D672TR is at your command!
EN01-42.CA-D672TR[E]/F 05.3.24, 9:21 PM5
To Next Page
Loading...
Need help?
General
