7
English
¤
To adjust the voltage selector
Preparing the remote control
• Dispose of batteries in the proper manner, according to
federal, state, and local regulations.
To remove the speaker grilles of the front speakers
Use a screwdriver to rotate the
voltage selector so that the voltage
mark is pointing at the same voltage
as where you are plugging in the unit.
(See also the back cover page.)
DO NOT plug in before setting the voltage
selector and all connection procedures are
complete.
Holes
Speaker grille
Projection
Voltage mark
When using the remote
control,
point the top of the
remote control toward the
remote sensor as directly as
possible. If you operate it
from a diagonal position,
the operating range (approx.
5 m) may be shorter.
DO NOT recharge, short, disassemble or
heat the battery or dispose of it in a fire.
R6(SUM-3)/AA(15F)
DX-T7_T9[USUN]-f.book Page 7 Wednesday, February 16, 2005 1:12 PM
To Next Page
Loading...
Need help?
General
