EasyManuals Logo
Home>JVC>Projector>DLA-X3

JVC DLA-X3 User Manual

JVC DLA-X3
79 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
18
1
Getting started
Controls and features (continued)
Main body - Input terminal
HDMI 1 HDMI 2 LAN
COMPONENT
TRIGGER
REMOTE
3D SYNCHRO
PC
RS-232C
HDMI 1 Terminal
You can connect a device equipped with HDMI
output, etc. It is tted to the M3 lock hole.
Screw hole depth 3mm. (Reference page: 26)
HDMI 2 Terminal
You can connect a device equipped with HDMI
output, etc. It is tted to the M3 lock hole.
Screw hole depth 3mm. (Reference page: 26)
LAN terminal
RJ-45
X7 X9
This is a LAN-terminal. If one connects an
external PC, it is possible to control this unit by
sending control commands. (Reference page:
30)
RS-232C terminal (male D-Sub 9
pin)
This is a RS-232C interface standard terminal.
If one connects an external PC, it is possible to
control this unit. (Reference page: 29)
COMPONENT terminal
RCAx3
It is also used as input terminal for analog
RGB (G on Sync) signals, component (Y, Cb,
Cr) signals, DTV format (Y, Pb, Pr) signals. It
can also be connected with devices, which are
equipped with signal output, etc. (Reference
page: 27)
3D SYNCHRO terminal
3D synchro emitter: it is connected to the PK-
EM1 (sold separately) when enjoying 3D video
contents. (Reference page: 28)
PC terminal
D-Sub 15 pin
X7 X9
This is an input term used for Personal Computer
(PC) signals only (RGB video signals and sync
signals). Use to connect a computer display
output terminal, etc. (Reference page: 28)
TRIGGER terminal( )
DC power supply output terminal with DC12V,
100mA. It is used for output signals which control
the vacillating screen responding to the SCREEN
TRIGGER. Please note it can cause damage
to your equipment if the connection is done
incorrectly. (Tip = DC +12 V, Sleeve = GND)
(Reference Page: 29, 54)
REMOTE terminal to
Stereo mini
jack
In case it is impossible to use the remote control
due to the installation of this unit
s dedicated
BOX or rear projection, one can set up an
external light receiving section. It is used to
connect this external receiver and this unit. There
is no such product as an external light receptor.
Therefore, please consult your authorized JVC
service center. (Reference page: 30)
X7 X9
X7 X9

Table of Contents

Other manuals for JVC DLA-X3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC DLA-X3 and is the answer not in the manual?

JVC DLA-X3 Specifications

General IconGeneral
BrandJVC
ModelDLA-X3
CategoryProjector
LanguageEnglish

Related product manuals