Procedures for adjusting the image when gamma is set to “D”
If the image appears dark when gamma is set to “D”, it is recommended to adjust the image according to the following
procedures.
A
While checking the overall image, adjust the setting value of “Picture Tone” in the + direction.
B
Focus on the bright area of the image and adjust the setting value of “Bright Level” in the + direction until the bright
area appears appropriate.
C
Focus
on the dark area of the image and adjust the setting value of “Dark Level” in the + or - direction until the dark
area appears appropriate.
Reducing the After-image of Fast-moving Images (Blur Reduction)
Clear Motion Drive (C.M.D.)
Optimal interpolation according to the content is made possible with the new high-definition image interpolation
technique that supports 3D images.
For some scenes, interpolation may cause distortion in the image. In this case, set to “Off”.
.
Intermediate Frame GenerationIntermediate Frame Generation
Interpolation Enabled
Original Image
1
Press the [C.M.D.] button
0
Pressing the [C.M.D.] button each time switches the mode in the following
sequence: “Off”"“Low”"“High”"“Inverse Telecine”"“Off”...
Setting Description
Off Interpolation is not performed.
Low Softens the image quality.
High Image quality becomes softer than that of the “Low” setting.
Inverse Telecine 60i/60p video images such as those of TVs and DVDs.
Suitable
for original images that are 24-frame film sources.
0
Does not function for 24p video images.
* C.M.D. is the abbreviation for Clear Motion Drive.
HDMI 1
INPUT
LENS MEMORY
HDMI 2 INFO.
MEMORY
MENU
MEMORY1 MEMORY2
LENS
CONTROL
LENS AP.
C.M.D.
39
Adjust/Set
To Next Page
Loading...
Need help?
General
