1-12 (No.MB396)
3.1.6 Removing the tuner
(See Figs.11 and 12)
• Remove the top cover and rear panel.
(1) From the top side of the main body, remove the two screws
N attaching the bridge C. (See Fig.11.)
Reference:
When attaching the screws N, attach the lug wires with
them. (See Fig.11.)
(2) Release the claws b of the tuner holder and take out the
tuner from the main body. (See Fig.12.)
(3) Disconnect the card wire from the connector CN1
on the
tuner. (See Fig.12.)
Fig.11
Fig.12
3.1.7 Removing the headphone board
(See Fig.13)
• Remove the top cover, AL panel L, AL panel R and front panel
assembly.
(1) From the left side of the main body, disconnect the wire
from the connector CN401
on the main board.
(2) Remove the screw P attaching the headphone board.
(3) Remove the engagement section c toward this side, re-
move the headphone board from the joint d in the direction
of the arrow.
Fig.13
Lug wire
Bridge C
N
N
Lug wire
b
Tuner
b
Card wire
CN1
d
Headphone board
CN401
Main board
P
c
To Next Page
Loading...
Need help?
General
