To Next PageTo Next PageTo Previous PageTo Previous Page
Why can't I operate my JVC FS-L30 with the remote control?
If you are unable to operate your JVC Speaker System using the remote control, first ensure that there is a clear path between the remote control and the remote sensor on the unit. Remove any obstructions that may be blocking the signal. The batteries may also be exhausted.
How to troubleshoot no sound on JVC FS-L30?
If your JVC Speaker System isn't producing any sound, start by checking all the connections to ensure they are correctly and securely in place. Also, make sure headphones are not plugged in, as this will prevent sound from coming through the speakers.
What to do if my JVC Speaker System operations are disabled?
If your JVC Speaker System operations are disabled, the built-in microprocessor may have malfunctioned due to external electrical interference. To resolve this, unplug the AC power cord from the outlet, wait a few seconds, and then plug it back in. This should reset the system and restore normal operation.
How to fix noisy broadcasts on JVC Speaker System?
If you find it hard to listen to broadcasts on your JVC Speaker System due to noise, it might be due to disconnected antennas. Reconnect the antennas correctly and securely. Also, try changing the position and direction of the AM loop antenna if it's too close to the unit, and ensure the FM antenna is fully extended and properly positioned.
What to do if the JVC FS-L30 disc tray won't open?
If your JVC Speaker System's disc tray won't open or close, ensure that the AC power cord is properly plugged in.
What causes discontinuous disc sound on JVC Speaker System?
If the sound from a disc is discontinuous on your JVC Speaker System, the disc may be scratched or dirty. Try cleaning or replacing the disc.
General| Impedance | 6 Ohms |
|---|---|
| Remote Control | Yes |
| Weight | 3.5 kg |
| Tuner Bands | AM/FM |
| CD Player | Yes |
| Woofer | 12 cm |
| Power Output | 20 Watts per channel (RMS) |
General warnings about opening the unit and internal voltage.
Warnings on usage, moisture, and installation.
Precautions for Class 1 Laser Product.
Description of buttons on the remote control.
Description of buttons and indicators on the main unit.
Instructions for attaching the speaker wires to the unit.
Instructions for standby and complete power off.
Controls for sound level, bass, and treble.
How to play a CD from start to finish.
Steps for recording audio from sources.
Copying entire CDs to tape.
Recording specific tracks from CD to tape.
Automating playback or recording schedules.
Troubleshooting steps for typical problems.
