8 EN
GETTING STARTED
Power
This camcorder’s 3-way power supply system lets you
choose the most appropriate source of power.
NOTES:
●
No function is available without power supply.
●
Use only specified power supply.
●
Do not use provided power supply units with other
equipment.
CHARGING THE BATTERY PACK
SUPPLY POWER
1
Connect the charger’s AC power cord to a wall
outlet.
ATTACH BATTERY PACK
2
Align the marks and slide the battery pack in the
direction of the arrow until it locks in place.
•The CHG. indicator begins blinking to indicate
charging has started.
DETACH BATTERY PACK
3
When the CHG. indicator stops blinking but stays
lit, charging is finished. Slide the battery pack
opposite the direction of the arrow.
ATTENTION:
Before detaching the power source,
make sure that the camcorder’s power
is turned off. Failure to do so can result
in a camcorder malfunction.
CHG. (charge)
indicator
Marks
To AC outlet
REFRESH indicator
REFRESH switch
Push in.
Hook on.
BATT. RELEASE
1
1
2
REFRESH
The AC power adapter features a REFRESH
function that allows you to fully discharge
the battery pack before recharging. Perform
the REFRESH function after no less than 5
chargings.
To discharge the battery . . .
..... attach the battery pack to the adapter
as shown in the above illustration.
Then push REFRESH. The REFRESH
indicator lights when discharging
starts, and goes out when discharging
is complete.
USING THE BATTERY PACK
ATTACH BATTERY PACK
1
Hook its top end to the camcorder and push the
battery pack in until it locks in place.
DETACH BATTERY PACK
2
Slide BATT. RELEASE and pull out the battery pack.
BATT. PACK CHARGE DISCHARGE
BN-V11U approx. 1 hr. 10 min.
approx.
3 hrs. 30 min.
BN-V12U approx. 1 hr. 10 min.
approx.
3 hrs. 30 min.
BN-V22U approx. 2 hrs. 10 min. approx. 7 hrs.
BN-V25U approx. 2 hrs. 40 min. approx. 10 hrs.
BATT. PACK
Approximate recording time (unit: min.)
BN-V11U 75 ( 40 )
BN-V12U 75 ( 40 )
BN-V22U 150 ( 90 )
BN-V25U 200 ( 120 )
( ) : when the video light is on.
To Next Page
Loading...
Need help?
General
