EN 23
FEATURE: Quick Review
PURPOSE: To check the end of the last record-
ing.
OPERATION: 1)Press “ ” and release quickly
during the Record–Standby mode.
n Tape is rewound for about 2
seconds and played back
automatically, then pauses in
Record–Standby mode for the
next shot.
NOTE:
Distortion may occur at start of
playback. This is normal.
FEATURE: Retake
PURPOSE: To re-record certain segments.
OPERATION: 1)Make sure the camcorder is in the
Record–Standby mode.
2)Press either RETAKE button to
reach the start point for new
recording. Pressing “F” forwards
the tape and pressing “R” reverses
it.
3)Press Recording Start/Stop Button
to start recording.
NOTE:
Noise may appear during Retake.
This is normal.
FEATURE: Picture Stabilizer
PURPOSE: To compensate for unstable images
caused by camera-shake, particularly
at high magnification.
OPERATION: 1)Press P. STABILIZER. “ ”appears.
n To switch off the Picture
Stabilizer, press P. STABILIZER.
The indicator disappears.
NOTES: ●
Accurate stabilization may not be
possible if hand shake is excessive,
or under the following conditions:
•
When shooting subjects with
vertical or horizontal stripes.
•
When shooting dark or dim
subjects.
•
When shooting subjects with
excessive backlighting.
•
When shooting scenes with
movement in various directions.
•
When shooting scenes with low-
contrast backgrounds.
●
Switch off the Picture Stabilizer
when recording with the
camcorder on a tripod.
P. STABILIZER
RETAKE (R/F)
To Next Page
Loading...
Need help?
General
