EN
6
Automatic Demonstration takes place when
“DEMO MODE” is set to “ON” (factory-preset).
䡲 Automatic Demonstration starts when there is no operation for
about 3 minutes after the Power Switch r is set to “ ” or “ ”
and no cassette is in the camcorder.
䡲 Performing any operation during the demonstration stops the
demonstration temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will resume.
䡲 “DEMO MODE” remains “ON” even if the camcorder power is
turned off.
䡲 To cancel Automatic Demonstration:
1. Set the Power Switch r to “ ” while pressing down the Lock
Button e located on the switch and press the MENU/VOLUME
wheel # in. The Menu Screen appears.
2. Rotate the MENU/VOLUME wheel # to select “ (SYSTEM)”
and press it.
3. Rotate the MENU/VOLUME wheel # to select “DEMO MODE”
and press it. The Sub Menu appears.
4. Rotate the MENU/VOLUME wheel # to select “OFF” and press
it.
5. Rotate the MENU/VOLUME wheel # to select “ RETURN”,
and press it twice. The normal screen appears.
NOTE:
If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on
the LCD monitor or viewfinder.
AUTOMATIC DEMONSTRATION
None
RETURN
OFF
ON
EMO MODED –
SYSTE
M
r
#
e
Sub Menu
GR-D22_1-10_EN 25/9/03, 3:23 PM6
To Next Page
Loading...
Need help?
General
