To Next Page

To Previous Page

1-18 (No.YF075)

SECTION 5

TROUBLE SHOOTING

5.1 SERVICE NOTE

Symbol No.

Removing order of screw

Place to stick screw

Reference drawing (Fig.No.)

Screw tightening torque

Symbol No.

Removing order of screw

Place to stick screw

Reference drawing (Fig.No.)

Screw tightening torque

Removing order of screw

Place to stick screw

Reference drawing (Fig.No.)

Screw tightening torque

Removing order of screw

Place to stick screw

Reference drawing (Fig.No.)

Screw tightening torque

[1]

FA1 FA2 FA3 FA4 FA5-2

FA5-1

12345678910111213141516

12345

㧖㧖㧖㧖㧖㧖㧖㧖㧖㧖㧖㧖㧖㧖㧖㧖㧖

[2] [5] [6][3]

[4]

CABINET PARTS AND ELECTRICAL PARTS(1)

1234567891011

3-2-3-2

VF1

3-2-3-33-2-3-1

[2]

MONITOR ASSY

[3]

VF ASSY

1234567891011

3-2-4

[7]

[7] O

P BLOCK ASSY / CCD BOARD ASSY

NOTE:

㧝㧖 (This mark shows where to attach the screws) : Do not reuse the screws because the screw lock bond was applied to prevent the screws from loosening.

Prepare the specified screws and use them in place of the removed screws.

㧞Tightening torque for the screws

࡮There are setting limits of the torque value for the torque driver. If the value exceeds the setting value, take it as a rough measurement (reference value),

and tighten the screw manually.

࡮The specified torque value is a recommended value of the initial assembly. Therefore, set the value below the specified torque value in the assembling procedure.

Be careful not to break either the screws or the screw holes.