VIDEO PLAYBACK
VIDEO RECORDING & PLAYBACK
EN 15
MasterPage: Video_Right
The Full-Function Remote Control Unit can operate this
camcorder from a distance as well as the basic
operations (Playback, Stop, Pause, Fast-Forward and
Rewind) of your VCR. It also makes additional playback
functions possible. (墌 pg. 16)
Installing The Battery
The remote control uses one
lithium battery (CR2025).
1 Pull out the battery holder
by inserting a pointed
instrument into the slot.
2 Insert the battery in the
holder, and be sure to have
the “+” mark visible.
3 Slide the holder back in
until you hear a click.
Beam Effective Area
(indoor use)
When using the remote control,
be sure to point it at the remote
sensor. The transmitted beam’s
approximate effective distance
for indoor use is 5 m (16 ft).
NOTE:
The transmitted beam may not be
effective or may cause incorrect
operation when the remote sensor
is directly exposed to sunlight or powerful lighting.
Buttons And Functions
A Infrared beam transmitting window
The following buttons are available only when the
camcorder’s Power Switch is set to “PLAY”.
B AUDIO Button ..................................... (墌 pg. 25, 28)
C PAUSE Button* .......................................... (墌 pg. 16)
Up Button .................................................. (墌 pg. 16)
D SLOW Rewind Button................................ (墌 pg. 16)
E REW Button* ....................................... (墌 pg. 14, 20)
Left Button ................................................ (墌 pg. 16)
F INSERT Button .......................................... (墌 pg. 37)
G STOP Button* ...................................... (墌 pg. 14, 20)
Down Button ............................................. (墌 pg. 16)
H SHIFT Button ............................................ (墌 pg. 16)
I EFFECT ON/OFF Button .......................... (墌 pg. 16)
J EFFECT Button ........................................ (墌 pg. 16)
K SLOW Forward Button............................... (墌 pg. 16)
L FF Button* ........................................... (墌 pg. 14, 20)
Right Button .............................................. (墌 pg. 16)
M PLAY Button* ....................................... (墌 pg. 14, 20)
N A. DUB Button ........................................... (墌 pg. 37)
O DISPLAY Button ................................. (墌 pg. 17, 34)
The following buttons are available when the camcorder’s
Power Switch is set to “A” or “M”.
a S.SHOT (Snapshot) Button*
b START/STOP Button*
c Zoom (T/W) Buttons** ........................ (墌 pg. 12, 16)
* Functions the same as each corresponding button on the
camcorder. (墌 pg. 51)
** Functions when the camcorder’s Power Switch is set to
“PLAY” as well.
Playback Using The Remote Control
1
1
2
3
Slot
Remote sensor
T
W
GR-D94US.book Page 15 Monday, November 17, 2003 2:12 PM