52 EN
TROUBLESHOOTING
(cont.)
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
15.
The Picture Wipe and
Dissolve functions do not
work.
16.
The picture wipe function
does not work.
17.
Scene transition does not
go as expected.
18.
The Video Echo mode
does not work.
15.
•The last selected editing
scene is ending.
•At the end of the last
selected scene for editing,
the Power Switch was set to
“OFF”.
•The power is off.
16
•The Slow Shutter mode is
activated.
•“WIDE MODE” is not set to
“OFF”.
17.
•When using “Picture Wipe/
Dissolve” (墌 pg. 24), there
is a delay of a fraction of a
second between the
previous record stop-point
and the Dissolve start-point.
This is normal, but this slight
delay becomes especially
noticeable when shooting
fast-moving subject or
during rapid panning.
18.
•The Picture Wipe or
Dissolve functions are in use.
•“WIDE MODE” is set to
“SQUEEZE” in the Menu
Screen.
•A Fade-In or Fade-Out is in
progress.
15.
•Select Picture Wipe or
Dissolve before beginning
recording. The effects are
then automatically activated
(墌 pg. 24).
•Do not turn off the
camcorder’s power after
setting Edit-In and Edit-Out
points, as they will all be
erased (墌 pg. 24).
•The camcorder automati-
cally shuts off after 5 minutes
have elapsed in the Record-
Standby mode. Make sure
you continue operations
within 5 minutes after
engaging Record-Standby
mode (墌 pg. 24).
16.
•Disengage the Slow Shutter
mode or set “WIDE MODE”
to “OFF” before preparing
to use the Picture Wipe
(墌 pg. 22, 24, 26).
17.
————
18.
•Set “WIDE MODE” to
“CINEMA” or “OFF” mode
(墌 pg. 22).
•Do not try to use the Video
Echo mode during a Fade-In
or Fade-Out (墌 pg. 24, 26).
To Next Page
Loading...
Need help?
General
