EasyManuals Logo
Home>JVC>Camcorder>GR-DVL320A

JVC GR-DVL320A User Manual

JVC GR-DVL320A
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
68
EN
If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.
The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,
etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery
pack, AC Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the
beginning.
TROUBLESHOOTING
The power is not connected
properly.
The battery is dead.
The date/time is not set.
The built-in clock battery has run
out and the previously set date/time
has been erased.
— For Tape Recording —
The tape’s erase protection tab is
set to “SAVE”.
The Power Switch is set to “PLAY”
or “OFF”.
The VIDEO/MEMORY Switch is set
to “MEMORY”.
“TAPE END” appears.
The cassette holder cover is open.
— For Memory Card Recording —
The VIDEO/MEMORY Switch is set
to “VIDEO”.
The camcorder is not getting power,
or some other malfunction exists.
Focus is set to the Manual mode.
The recording was done in a dark
place, or the contrast was low.
The lens is dirty or covered with
condensation.
Connect the AC Adapter securely
(
pg. 9).
Replace the dead battery with a
fully charged one (
pg. 8, 9).
Set the date/time ( pg. 11).
Consult your nearest JVC dealer
for replacement.
Set the tape’s erase protection tab
to “REC” (
pg. 12).
Set the Power Switch to “
A
U
TO
” or
MANUAL
” ( pg. 17).
Set the VIDEO/MEMORY Switch to
“VIDEO”.
Replace with new cassette
(
pg. 12).
Close the cassette holder cover.
Set the VIDEO/MEMORY Switch to
“MEMORY”.
Turn the camcorders power off and
on again (
pg. 17).
Set Focus to the Auto mode
(
pg. 41).
Clean the lens and check the focus
again (
pg. 74).
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
1 No power is supplied.
2 “SET DATE/TIME!” appears.
3 Recording cannot be
performed.
4 There is no picture.
5 The focus does not adjust
automatically.

Table of Contents

Other manuals for JVC GR-DVL320A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC GR-DVL320A and is the answer not in the manual?

JVC GR-DVL320A Specifications

General IconGeneral
BrandJVC
ModelGR-DVL320A
CategoryCamcorder
LanguageEnglish

Related product manuals