EN 7
Master Page: Right
GR-DVP7U_02-08.fmPage 7
How To Attach The Grip Belt
1) Remove the pad and separate the two straps.
2) Thread one end of the strap g through the eyelet,
then pass the other end through the loop.
3) Repeat the same procedure to attach the strap h
to the other eyelet.
4) Connect the strap g and h and thread the strap
h through the buckle, then adjust the grip.
(墌 pg. 12)
5) Attach the pad.
How To Attach The Strap
1) Thread one end of the strap through the eyelet,
then pass the other end through the loop.
2) Attach the screw to the tripod mounting socket.
To tighten the screw firmly, use a coin, etc.
3) Adjust the length with the adjuster.
NOTES:
● You can use the strap as a shoulder strap by
adjusting the length with the adjuster.
● Because the screw may cause damage to the
camcorder, make sure to attach the screw to the
tripod mounting socket when carrying the
camcorder.
● Use the strap only with this camcorder.
● Do not grip the camcorder too firmly when the
screw is attached. Doing so may cause damage to
the tripod mounting socket.
h
g
GR-DVP7U_02-08.fm Page 7 Wednesday, February 27, 2002 5:23 PM
Downloaded From VideoCamera-Manual.com Manuals
To Next Page
Loading...
Need help?
General
