JVC GR-DVX10 User Manual

EN5
AUTOMATIC DEMONSTRATION
Automatic Demonstration takes place when
“DEMO. MODE” is set to “ON” (factory-preset).
 Available when the POWER Switch is set to “ ” and no
cassette is in the camcorder.
 Performing any operation during the demonstration stops the
demonstration temporarily. If no operation is performed for
more than 1 minute after that, the demonstration will resume.
 “DEMO. MODE” remains “ON” even if the camcorder power
is turned off.
 To cancel Automatic Demonstration, set the Operation Switch
to “ ” and set the POWER Switch to “ ” while pressing
down the Lock Button located on the switch, then press the
MENU wheel twice while the demo is in progress. This takes
you directly to the demo mode’s Setting Menu (so you will not
have to go through the Menu Screen). Rotate the MENU wheel
to select “OFF” and press it. The normal screen appears.
1
R
S
Z
S
G
B
I
D
R
E
O
O
N
A
E
D
E
E
C
U
O
A
I
E
M
C
T
N
M
P
N
P
N
O
A
U
M
D
/
U
.
M
R
O
M
U
T
M
E
N
D
M
O
P
A
B
M
R
E
O
D
L
E
O
A
D
E
L
R
D
E
Y
E
ME
O
O
N
N
F
U
F
MENU Wheel
How To Attach Core Filters
Attach the provided Core Filters to an optional S-Video cable or Audio/Video (RCA plug – RCA plug) cable.
Core Filters reduce interference.
Release the
stoppers on both
ends of the Core
Filter.
Run the cable through the Core Filter, leaving approx.
3 cm of cable between the cable plug and the Core
Filter. Wind the cable around the outside of the Core
Filter as shown in the illustration.
•Wind the cable so that it is not slack.
NOTE:
Take care not to damage the cable.
Close the Core Filter until it
clicks shut.
3 cm
Stopper
 When connecting cables, attach the end with the Core Filter to the camcorder.
12 3
Wind once

JVC GR-DVX10 Specifications

General

Brand	JVC
Model	GR-DVX10
Category	Camcorder
Language	English