Y
M
D
T
E
E
O
A
I
X
A
N
Y
M
I
R
T
E
T
H
DATE/TIME
2
2
0
0
:
0
2
2
1
6
8
0
24-hour
indication
Menu Screen
DATE/TIME Menu
MENU Wheel
Power Switch
Display
Date/Time Settings
1
Set the Power Switch to “ ”. The power lamp
comes on.
2
Press MENU. The Menu Screen appears.
3
Rotate MENU to select “ TO SYSTEM MENU” and
press it to display SYSTEM MENU. Rotate MENU to
select “
NEXT” and press it to display the next page.
4
Rotate MENU to select “DATE/TIME” and press it.
The DATE/TIME Menu appears.
5
To set “YEAR”, “MONTH”, “DAY” or “TIME” (hour/
minute), rotate MENU to select the desired item, and
press it. When the setting begins blinking, rotate
MENU until the correct setting appears and then
press it. The setting stops blinking.
6
When none of these settings (“YEAR”, “MONTH”,
“DAY”, “TIME”) blinks, rotate MENU to select “EXIT”,
and press it. The Menu Screen reappears with the
highlight bar on “
RETURN”.
7
Press MENU to close the Menu Screen.
NOTE:
To display the date and time in the camcorder’s display and
on a connected TV, see “Date/Time Insert” (
Z
pg. 25).
VIDEO OUT
Menu
Video Out Setting (French model only)
Set to “PAL” or “SECAM” according to the system of the
TV or VCR you will be using.
NOTE:
If you change the PAL/SECAM setting during playback, the
playback picture colour may be affected. Be sure to
choose the correct setting before you start shooting.
1
Perform steps 1 through 3 above.
2
Rotate MENU to select “VIDEO OUT” and press it.
The VIDEO OUT Menu appears.
3
Rotate MENU to select the desired mode, then press
it. The desired mode is activated.
4
The Menu Screen reappears with the highlight bar on
“
RETURN”. Press MENU to close the Menu Screen.
NOTE:
Recordings are made in PAL with this
camcorder. If you wish to play back recorded
tapes on a VCR or camcorder other than this
unit, be sure to use a PAL VCR or camcorder.
For other notes, Z pg. 44