Charging the Battery Pack
1
Close the LCD monitor to turn off the
camera.
2
Attach the battery pack.battery pack.
Slide the battery pack down until it locks
in place.
Bottom of the Camera
3
Connect the AC adapter.
•
If the provided AC adapter is AP-V14E,
connect the power cord to the AC adapter,
and plug the power cord into an AC outlet.
•
You can also connect the AC adapter using
the Everio dock connector. (p. 9)
•
The power/charge lamp blinks to indicate
charging has started.
•
When the lamp goes out, charging is
finished. Unplug the AC adapter from the
AC outlet and disconnect the AC adapter
from the camera.
7
To detach the battery pack
Slide and hold BATT. (step 2), then
remove the battery pack.
7
To check the remaining battery power
See page 15.
NOTES
•
You can also use the camera with just the
AC adapter.
•
Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.
Necessary Settings before Use
DC Jack
AC Adapter
To AC Outlet
(110V to 240V)
Date/Time Setting
1
Open the LCD monitor to turn on the
camera.
2
When [SET DATE/TIME!] appears,
select [YES] within 10 seconds.
If you do not select within 10 seconds, the
screen disappears. In such case, press
the POWER button and turn the camera
on again.
3
Set the date and time.
Repeat this step to input the day, month,
year, hour and minute.
4
Touch the OK button to finish.
7
To change the date and time
1) Touch the MENU button.
2) Select [BASIC SETTINGS], and then
[CLOCK ADJUST].
3) Set the date and time.
7
To return to the previous screen
Select @.
7
To quit the screen
Touch the MENU button.
To Next Page
Loading...
Need help?
General
