JVC KD-DB52 Installation Manual

.
.
Lead terminal
Sheet
䎬䎬䎬
0
Do not touch the lead terminal.
7
Remove the Sheet III.
.
0
Do not touch the lead contact or the sticky
surface of the adhesive tape on the booster.
<When installing on the right side>
.
Align the protrusion with
K
mark
Booster
Lead contact
of the booster
(metal part)
Earth sheet
Lead terminal
of the lm aerial
Film aerial A
<When installing on the left side>
.
Align the protrusion with
J
mark
Earth sheet
Film aerial
A
Booster
8
Align the protrusion of the booster with the
K mark on the film aerial A so that the lead
contact of the booster (metal part) is in
contact with the lead terminal of the film
aerial.
.
<Cross-section>
.
Booster
Earth sheet
Front pillar
Windscreen
9
Paste the earth sheet onto the metal part of
the front pillar. (Pasting onto the painted
metal part is also acceptable.)
10
Connect the cable to the DAB aerial input
on the rear panel of the unit. (A page 3)
11
Secure the cable to the pillar at several
locations using the cable clampers C.
.
<Cross-section>
.
Booster
Front pillar cover
Earth sheet
.
0
Ensure that the front pillar cover does not
damage the earth sheet and booster.
12
Attach the front pillar cover back to its
original position.
.
0
Initial setting: <ANT PWR ON>
.
A
B
.
(Hold)
B<TUNER>
B<DAB ANT PWR>
B<ANT PWR ON>
.
C
Press MENU to exit.
0
There will be no reception if <ANT PWR OFF> is
set.
A
B
13
Check that the DAB aerial power is set to
“ON”.
Installing the DAB aerial
ENGLISH |
5

JVC KD-DB52 Specifications

General

Brand	JVC
Model	KD-DB52
Category	Car Receiver
Language	English