8
ENGLISH
LVT1008-001A [E/EX]
Setting the clock
1
Press and hold SEL (S) for more
than 2 seconds so that one of the
PSM items appears on the display.
(See pages 31 and 32.)
2
Set the hour.
1 Select “CLOCK HOUR” if not shown on
the display.
2 Adjust the hour.
3
Set the minute.
1 Select “CLOCK MIN (minute).”
2 Adjust the minute.
4
Set the clock system.
1 Select “24H/12H.”
2 Adjust “24HOUR” or “12HOUR.”
5
Finish the setting.
To check the current clock time with “CLOCK
DISP” set to “CLOCK OFF,” press DISP (D).
The clock time is shown for 5 seconds.
Canceling the demonstration
When shipped from the factory, demonstration
has been activated, and starts automatically
when no operations are done for about 20
seconds.
• It is recommended to cancel the demonstration
before you use the unit for the first time.
To cancel the demonstration, follow the
procedure below.
1
Press and hold SEL (S) for more
than 2 seconds so that one of the
PSM items appears on the display.
(See pages 31 and 32.)
2
Select “DEMO MODE” if not shown
on the display.
3
Select “DEMO OFF.”
4
Finish the setting.
To activate the demonstration again, repeat
the same procedure and select “DEMO ON” in
step
3
.
2
1
2
1
2
1
SEL
S
SEL
S
SEL
S
EN07-08KD-LX555R[E]f.p65 02.12.11, 16:158
To Next Page
Loading...
Need help?
General
