ENGLISH
15
Other external component
operations
You can connect an external component to the AUX
(auxiliary) input jack on the control panel.
~
Ÿ
Turn on the connected component and
start playing the source.
! Adjust the volume.
⁄ Adjust the sound as you want.
(See pages 11 and 12.)
To check the clock time while listening to an
external component
Portable audio player,
etc.
Stereo mini plug
(not supplied)
AUX IN Ô Clock
Maintenance
How to clean the connectors
Frequent detachment will deteriorate the connectors.
To minimize this possibility, periodically wipe the
connectors with a cotton swab or cloth moistened with
alcohol, being careful not to damage the connectors.
Moisture condensation
Moisture may condense on the lens inside the unit in
the following cases:
• After starting the heater in the car.
• If it becomes very humid inside the car.
Should this occur, the unit may malfunction. In this
case, eject the disc and leave the unit turned on for a
few hours until the moisture has evaporated.
How to handle discs
When removing a disc from its
case, press down the center holder
of the case and lift the disc out,
holding it by the edges.
• Always hold the disc by the edges.
Do not touch its recording surface.
When storing a disc in its case, gently insert the
disc around the center holder (with the printed surface
facing up).
• Make sure to store discs in cases after use.
To keep discs clean
A dirty disc may not play correctly.
If a disc does become dirty, wipe it with
a soft cloth in a straight line from center
to edge.
• Do not use any solvents (for example,
conventional record cleaner, spray, thinner, benzine,
etc.) to clean discs.
Center holder
Connectors
Continued on the next page
EN14-19_KD-R201_006A_1.indd 15EN14-19_KD-R201_006A_1.indd 15 8/7/08 9:32:34 AM8/7/08 9:32:34 AM
To Next Page
Loading...
Need help?
General
