1
KD-R526/KD-R426
Installation/Connection Manual
安裝/連接手冊
0910DTSMDTJEIN
EN, CT
© 2010 Victor Company of Japan, Limited
GET0702-010A
[UT]
Bracket / 托座 *
Pocket /
空殼
Flat head screws (M5 × 8 mm) /
平頭螺絲釘（M5 × 8 mm
) *
INSTALLATION / 安裝
When installing the unit without using the sleeve /
若不使用外套機殼安裝本機
In-dash mounting /
裝設、固定在儀表板內
• You need the installation kits which corresponds to your car.
• If you have any questions or require information regarding installation kits, consult your JVC car audio
dealer or a company supplying kits.
• The unit can only be installed in a car with a 12 V DC power supply, negative ground.
• Disconnect the battery’s negative terminal and make all electrical connections before installing the unit.
• Connect speakers with a maximum power of more than 50 W (impedance of 4 Ω to 8 Ω). Otherwise,
change the <AMP GAIN> setting. (See page 15 of the INSTRUCTIONS.)
• Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not
remove the caps on the ends of the unconnected wires or the terminals.
• If the fuse blows, first make sure the wires are not touching to cause a short circuit, then replace the old
fuse with one that has the same rating.
• Install this unit in the console of your vehicle.
• Mount the unit so that the mounting angle is 30° or less.
• Be sure to ground this unit to the car’s chassis again after installation.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working
properly.
• Do not touch the metal part of this unit during and shortly after the use of the unit. Metal part such as the
heat sink and enclosure become hot.
•
您需要與您的汽車相配套的安裝元件。
•
如果您有問題，或需要有關配套元件的資料，請向 JVC汽車音響分銷商或配套元件供應公司詢問。
•
本機僅可安裝在以直流 12 V 供電，負極接地的車內。
•
在安裝本機之前，拔開電池的負極端子，並把所有電路都連接好。
•
連接最大功率大於 50 W 的揚聲器（阻抗為 4 Ω – 8 Ω）。 否則，請切換 <AMP GAIN> 設定。 （參閱使用
說明書的第 15 頁。）
•
用絕緣帶或其他類似材料使未接上的電線絕緣。為防止電源短路，請勿除去未接上電線或端子兩端的保護蓋。
•
如果保險絲燒壞，首先請確認電線沒有接觸而導致短路，然後用相同負荷值的保險絲更換舊的保險絲。
•
將本機安裝在車內的控制台上。
•
安裝本機時安裝角度最大為 30
°
。
•
安裝完畢後務必將本機的地線重新接至車身。
•
安裝完本機後，請檢查車上的剎車燈，信號燈，雨刷等是否能正常工作。
•
請勿在使用本機的過程中和在使用本機後不久觸摸本機的金屬部分。金屬部分如散熱片和外殼變得很熱。
WARNINGS / 警告
Removing the unit /
拆卸本機
Release the rear section first... / 首先將本機後背部分鬆開...
Do the required electrical connections. /
進行所需的電路連接。
Bend the appropriate tabs to hold the sleeve
firmly in place. /
弄彎機殼的突舌，把外套機殼牢固在儀表板內。
Install the unit at an angle
of less than 30˚. /
將本機安裝在少於 30
°
的
角度。
* Not supplied for this unit.
*
不隨本機提供。
Part list / 零件清單
A
Hard case / 硬盒 (×1)
B
Control panel / 控制面板 (×1)
C
Sleeve / 外套機殼 (×1)
D
Trim plate / 裝飾框 (×1)
E
Power cord / 電路連接用的配線束
(×1)
F
Handles / 板條型把手 (×2)
PRECAUTIONS on power supply and speaker connections
• DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be
seriously damaged.
• BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in
your car.
電源和揚聲器接線注意事項
•
切勿把揚聲器導線接頭接至電池，否則本機將會嚴重損壞。
•
在把揚聲器導線接頭接至揚聲器之前，檢查您汽車上的揚聲器線路。
ENGLISH / 中文
• The fuse blows.
]
Are the red and black leads connected correctly?
• Power cannot be turned on.
]
Is the yellow lead connected?
• No sound from the speakers.
]
Is the speaker output lead short-circuited?
• “MISWIRING CHK WIRING THEN RESET UNIT” appears on the display and no operation can be done.
]
Is the speaker output lead short-circuited or touches the chassis of the car/head unit? ; Have you reset
your unit?
• Sound is distorted.
]
Is the speaker output lead grounded? ; Are the “–” terminals of L and R speakers
grounded in common?
• Noise interfere with sounds.
]
Is the rear ground terminal connected to the car’s chassis using shorter
and thicker cords?
• This unit becomes hot.
]
Is the speaker output lead grounded? ; Are the “–” terminals of L and R
speakers grounded in common?
• This unit does not work at all.
]
Have you reset your unit?
•
保險絲燒斷。
]
檢查紅色導線接頭和黑色導線接頭是否接觸正確？
•
電源不能接通。
]
檢查黃色導線接頭是否接上？
•
揚聲器沒有聲音。
]
檢查揚聲器輸出導線接頭是否短路？
•
“MISWIRING CHK WIRING THEN RESET UNIT ” 字樣在顯示窗上出現且無法進行任何操作。
]
檢查揚聲
器輸出導線是否短路或碰觸汽車底盤∕主機？ 您是否已經重置您的機組？
•
聲音失真。
]
檢查揚聲器輸出端子是否接地？ 檢查揚聲器的左（L）、右（R）端子的負極“–”是否共同
接地？
•
噪音干擾音響。
]
後接地端子與車身是否使用較短和較厚的電線連接？
•
本機發熱。
]
檢查揚聲器輸出端子是否接地？ 檢查揚聲器的左（L）、右（R）端子的負極“–”是否共同
接地？
•
本機完全不能操作。
]
您是否已經重置您的機組？
TROUBLESHOOTING / 故障排除
To Next Page
Loading...
Need help?
General
