1
KD-R716
Installation/Connection Manual
/
ENGLISH /
1209DTSMDTJEIN
EN, TH
© 2009 Victor Company of Japan, Limited
GET0648-006B
[U/UH]
Bracket / *
2
Pocket /
Flat head screws (M5 × 8 mm) / (M5 × 8 mm) *
2
INSTALLATION /
When installing the unit without using the sleeve /
In-dash mounting /
In-dash
• To prevent short circuits:
– Disconnect the battery’s negative terminal and make all electrical connections before installing the unit.
– Cover the terminals of the UNUSED leads with insulating tape.
• Be sure to ground this unit to the car’s chassis again after installation.
• Replace the fuse with one of the specified rating.
• Connect speakers with a maximum power of more than 50 W (impedance of 4 Ω to 8 Ω). Otherwise,
change the <AMP GAIN> setting. (See page 25 of the INSTRUCTIONS.)
• The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.
•
:
–
–
•
•
• 50 W ( 4 Ω 8 Ω)
<AMP GAIN> (
25 )
•
12 V DC, NEGATIVE ground /
12 V,
To the car system /
You need the installation kits which corresponds to your car. /
Check the battery system in your car /
WARNINGS /
Removing the unit /
Release the rear section first... /
...
The following illustration shows a typical installation. If you have any questions or require information
regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
Heat sink /
JVC
Do the required electrical connections.
Bend the appropriate tabs to hold the sleeve firmly
in place.
Install the unit at an angle of
less than 30˚.
30˚
*
1
*
1
When you stand the unit, be careful not to damage the fuse on the rear.
*
2
Not supplied for this unit.
*
1
*
2
Part list /
A Hard case / (×1)
B Control panel / (×1)
C Sleeve / (×1)
D Trim plate / (×1)
E Power cord / (×1)
F Handles /
(×2)
G Microphone / (×1)
H Microphone clips /
(×2)
I KS-UBT1: USB
Bluetooth adapter /
USB (×1)
PRECAUTIONS on power supply and speaker connections
• DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be
seriously damaged.
• BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in
your car.
•
•
To Next Page
Loading...
Need help?
General
