JVC KD-R746BT User Manual

10
BLUETOOTH®
Character search
You can search through the contacts quickly according to the first character (A to Z,
0 to 9, and OTHERS).
•
“OTHERS” appear if the first character is other than A to Z, 0 to 9.
1 Press .
2 Turn the volume knob to select [PHONEBOOK] , then press the knob.
3 Press 1 ∞ / 2 5 to select the desired character.
4 Turn the volume knob to select the desired contact, then press the knob to
call.
Use Voice Recognition
1 Press and hold to enter Voice Recognition mode.
If two phones are connected, turn the volume knob to select the desired phone,
then press the knob.
2 Speak the name of the contact you want to call or the voice command to
control the phone functions.
• Supported Voice Recognition features vary for each phone. Refer to the instruction
manual of the connected phone for details.
• This unit also supports the intelligent personal assistant function of iPhone.
Store a contact in memory
You can store up to 6 contacts.
1 Press .
2 Turn the volume knob to select [RECENT CALL] , [PHONEBOOK] , or [DIAL NUMBER] ,
then press the knob.
3 Turn the volume knob to select a contact or enter a phone number.
4 Press and hold one of the number buttons (1 to 6).
“MEMORY PX” flashes when the contact is stored.
To erase a contact from the preset memory, select [DIAL NUMBER] in step 2 and store
a blank number.
Make a call from memory
1 Press .
2 Press one of the number buttons (1 to 6).
3 Press the volume knob to call.
“NO PRESET” appears if there are no contacts stored.
Delete a contact
Only when
[P.BOOK SEL] is set to [PB IN UNIT] . ( ➜ 9)
1 Press .
2 Turn the volume knob to select [RECENT CALL] or [PHONEBOOK] , then press the
knob.
3 Turn the volume knob to select a contact or enter a phone number.
4 Press and hold G.
5 Turn the volume knob to select [DELETE] or [DELETE ALL] , then press the knob.
DELETE : Selected name or phone number in step 3 is deleted.
DELETE ALL : All names or phone numbers from the selected menu in step 2 is
deleted.
Bluetooth compatibility check mode
You can check the connectivity of the supported profile between the Bluetooth
device and the unit.
1 While pressing and holding , press and hold the volume knob for about
3 seconds.
“BLUETOOTH” Ô “CHECK MODE” appears.
2 Search and select “JVC UNIT” on the Bluetooth device within 3 minutes.
“PAIRING OK” appears and Bluetooth compatibility check starts.
The connectivity result flashes on the display for 30 seconds.
• “H.FREE OK” Ô “[Device Name]” : Compatible with Hands-Free Profile (HFP)
• “A. STREAM OK” Ô “[Device Name]” : Compatible with Advanced Audio
Distribution Profile (A2DP)
• “CONNECT FAIL” Ô “TRY CONNECT” : Not compatible
• To exit, turn off the unit by pressing and holding L SOURCE.
EN_KD-R746BT[U]001A_f.indd 10EN_KD-R746BT[U]001A_f.indd 10 2/27/13 9:55:28 AM2/27/13 9:55:28 AM

JVC KD-R746BT Specifications

General

Brand	JVC
Model	KD-R746BT
Category	Car Receiver
Language	English