JVC KD-R746BT User Manual

12
AUDIO SETTINGS
Other settings
1 Press and hold MENU.
2 Turn the volume knob to select [EQ SETTING] or [AUDIO] , then press the knob.
3 Turn the volume knob to make a selection (see the following table), then
press the knob.
Repeat step 3 until the desired item is selected.
4 Press MENU to exit.
Default:
XX
EQ SETTING
EQ PRESET
FLAT / NATURAL / DYNAMIC / VOCAL BOOST / BASS BOOST /
USER: Selects a preset equalizer.
EASY EQ
Adjust your own sound settings.
SUB.W *
1
–08 to +08 (00)
BASS LVL –06 to +06 (00)
MID LVL –06 to +06 (00)
TRE LVL –06 to +06 (00)
• The setting is stored to [USER] in [EQ PRESET].
PRO EQ
1 BASS / MIDDLE / TREBLE: Select a sound tone.
2 Adjust the sound elements of the selected sound tone.
BASS Frequency: 60/ 80/ 100/ 200 Hz Default: (80 Hz)
Level: –06 to +06 (00)
Q: Q1.0/ Q1.25/ Q1.5/ Q2.0 (Q1.0)
MIDDLE Frequency: 0.5/ 1.0/ 1.5/ 2.5 kHz Default: (1.0 kHz)
Level: –06 to +06 (00)
Q: Q0.75/ Q1.0/ Q1.25 (Q1.25)
TREBLE Frequency: 10.0/ 12.5/ 15.0/ 17.5 kHz Default: (10.0 kHz)
Level: –06 to +06 (00)
Q: Q FIX (Q FIX)
• The setting is stored to [USER] in [EQ PRESET].
Default: XX
AUDIO
FADER
*
2
*
3
R06 — F06 (00): Adjusts the front and rear speaker output balance.
BALANCE
*
3
L06 — R06 (00): Adjusts the left and right speaker output balance.
BASS BOOST
+01 / +02: Selects your preferred bass boost level. ; OFF: Cancels.
LOUD
LOW / HIGH: Boosts low or high frequencies to produce a well-balanced sound
at low volume. ; OFF: Cancels.
VOL ADJUST
–05 — +05 (00): Presets the volume adjustment level of each source
(compared to the FM volume level). Before adjustment, select the source you
want to adjust. (“VOL ADJ FIX” appears if FM is selected.)
L/O MODE
SUB.W / REAR: Selects whether rear speakers or a subwoofer are connected
to the REAR/SW line out terminals on the rear panel (through an external
amplifier).
SUB.W
*
4
ON / OFF: Turns on or off the subwoofer output.
SUB.W LPF
*
5
THROUGH: All signals are sent to the subwoofer. ; LOW 55Hz / MID 85Hz /
HIGH 120Hz: Audio signals with frequencies lower than 55 Hz/ 85 Hz/ 120 Hz
are sent to the subwoofer.
SUB.W LEVEL
*
5
–08 — +08 (00): Adjusts the subwoofer output level.
HPF
LOW 100Hz / MID 120Hz / HIGH 150Hz: Audio signals with frequencies
lower than 100 Hz/ 120 Hz/ 150 Hz are cut off from the front/rear speakers. ;
OFF: All signals are sent to the front/rear speakers.
BEEP
ON / OFF: Activates or deactivates the keypress tone.
AMP GAIN
LOW POWER: Limits the maximum volume level to 30. (Select if the maximum
power of each speaker is less than 50 W to prevent damaging the speakers.) ;
HIGH POWER: The maximum volume level is 50.
*
1
Displayed only when [L/O MODE] is set to [SUB.W] and [SUB.W] is set to [ON] .
*
2
If you are using a two-speaker system, set the fader level to [00] .
*
3
This adjustment will not affect the subwoofer output.
*
4
Displayed only when [L/O MODE] is set to [SUB.W] .
*
5
Displayed only when [SUB.W] is set to [ON] .
EN_KD-R746BT[U]001A_f.indd 12EN_KD-R746BT[U]001A_f.indd 12 2/27/13 9:55:29 AM2/27/13 9:55:29 AM

JVC KD-R746BT Specifications

General

Brand	JVC
Model	KD-R746BT
Category	Car Receiver
Language	English