Menu item
Selectable setting (Initial: [XX])
Audio
Fad/Bal *4*5
R6 — F6[0]: Press / to adjust the front and rear speaker output balance.
L6 — R6[0]: Press / to adjust the left and right speaker output balance.
Loud
(Loudness)
Loud1/ 2/ 3: Boosts low and high frequencies to produce a well-balanced
sound at low volume levels.
[Off]: Cancels.
Volume Adjust
Level -5 — Level +5[Level 0]: Presets the volume adjustment level of
each source, compared to the FM volume level. Before adjustment, select
the source you want to adjust. (“FIX” appears if “FM” is selected.)
Subwoofer On/
Off
[On]: Turns on the subwoofer output.
Off: Cancels.
Subwoofer
Level *6
00 — 10[05]: Adjusts the subwoofer output level.
Subwoofer
Phase *6
[0 Deg] (normal)/180 Deg (reverse): Selects the subwoofer phase.
X’over HPF/LPF
For settings, ' page 23.
Beep
(Keytouch tone)
[On]/Off: Activates or deactivates the keypress tone.
Amplifier Gain
Off: Deactivates the built-in amplifier.
Low Power: Limits the maximum volume level to 30. (Select if the
maximum input power of each speaker is less than 50 W to prevent
damaging the speakers.)
[High Power]: The maximum volume level is 50.
Tuner
SSM
For settings, ' page 6. (Displayed only when the source is “FM”.)
IF Band
(Intermediate
frequency band)
[Auto]: Increases the tuner selectivity to reduce interference noises
between adjacent stations. (Stereo effect may be lost.)
Wide: Subject to interference noises from adjacent stations, but sound
quality will not be degraded and the stereo effect will remain.
AF-Regional *7
For settings, ' page 7.
P-Search *7
(Programme
search)
On/[Off]: Activates Programme Search (if <AF-Regional> is set to <AF> or
<AF-REG>) or deactivates.
News-Standby *7
On/[Off]: Activates or deactivates NEWS Standby Reception. (Displayed
only when the source is “FM”.) (' page 7)
Stereo/Mono Displayed only when the source is “FM”.
[Stereo]: Enables stereo FM reception.
Mono: Improves the FM reception but stereo effect will be lost.
Radio Timer
For settings, ' page 6.
*4 If you are using a two-speaker system, set the fader level to “0”.
*5 This adjustment will not affect the subwoofer output.
*6 Displayed only when <Subwoofer On/Off> is set to <On>.
*7 Only for FM Radio Data System stations.
Menu operations
ENGLISHޓ|
25
2012/2/15ޓ17:53:26KD-R90BT_E_EN
To Next Page
Loading...
Need help?
General
