JVC KD-S636 Service Manual

KS-FX230
1-6
1.
2.
3.
4.
5.
6.
7.
8.
9.
Remove the head amp PCB.
Remove the load arm ass'y.
Remove the cassette holder and holder arm ass'y.
Remove the sub chassis ass'y.
Remove the right and left pinch roller ass'y.
From the rear of the head plate, detach the mylar
washer e and the washer pressing the forward/
reverse plate down. (see Fig. 8)
Remove the screw F fixing the metal detection lever
and removal spring as shown in Fig. 8.
Remove the head plate.
Pull out the mode gear. (see Fig. 9)
Removing the head plate (see Fig. 8,9)
1.
2.
3.
4.
5.
6.
7.
8.
Remove the head relay PCB.
Remove the load arm ass'y.
Remove the cassette holder and holder arm ass'y.
Remove the sub chassis ass'y.
Remove the head plate.
Disengage the main belt from the flywheel ass'y.
(see Fig. 8)
Remove E washers f at the two positions which
secure the capstan shaft away from the surface.
(see Fig. 9)
Pull out the flywheel ass'y from the rear.
Removing the flywheel ass'y (see Fig. 9)
1.
2.
3.
4.
5.
6.
7.
Remove the head relay PCB.
Remove the load arm ass'y.
Remove the cassette holder and holder arm ass'y.
Remove the sub chassis ass'y.
Straighten the curved tab g securing the reel disk
PCB. (see Fig. 10)
Remove the two screws G fixing the reel disc PCB.
Remove the reel disk PCB.
Removing the reel disk PCB (see Fig. 10)
NOTE : When installing the mode gear, set it to the
arrow mark.
Forward/reverse plate
Spring
Metal tape detection lever
Main belt
Fig.8
Head plate
Capstan shaft
Marking
Mode gear
Fig.9
Reel desk PCB
Fig.10
e
F
f
f
g
G

JVC KD-S636 Specifications

General

Brand	JVC
Model	KD-S636
Category	Car Receiver
Language	English